Posts

Showing posts from September, 2017

H-King Junkers Ju-87B-2 Stuka 1400mm (55") ARF

Image
This is ARF kit and demands some knowlege and a lot of patience.
So let's start.

First is the wing, I would suggest you that you read manual very carefuly, count those hinges, they are different for flaps and ailerons. Also, be careful with static flaps, flaps and ailerons since there is left and right side ones.
Test fit everything before gluing.

Hinges are glued with CA glue. Each slot is cut for particular hinge type, but as said before, test fit hinges before gluing them.

Control surface hinges are all the same and you can't miss there.
When glue dries, mount control surfaces to hinges using M2 macnine screws provided. Use loctite on your bolts and don't tight too much those bolts, control surfaces need to move easily.

I would suggest that at this time you insert servo extension leads in both wings and fix them with some masking tape.

Mounting landing gears is easy, I used 5 min epoxy for wooden blocks that come into landing gear cowling (manual says use CA, it's up…

AKK K33 40CH FPV Audio Video Transmitter

Image
As with all AKK equipment received in past couple of months, this one comes well protected in the box.
What can you find in the box is the transmitter, standard stick antenna, connecting cables and short manual.



Transmitter itself has 2 buttons and 2 LED 7 segment displays which are really bright.
Weighting only 8.1 grams without antenna and cables it is suitable for any application like mini quad, RC airplane, flying wing etc.
Antenna connector is placed on the top of transmitter (there is a version with side antenna mount called K22) and it has standard 40 channels transmission divided into well known bands A,B,E,F and R.
Frequency chart is provided in the manual.
Changing band and frequency is really easy with provided 2 buttons on the side of the transmitter itself. One button changes band which is displayed on the first LED while second button changes frequency on that band and is displayed on the second LED display as a number from 1 to 8.
And that is it, select your preferred c…

AKK A5 FPV AIO split system

Image
There are a lot of similar products you can find in various Chinese shops, I had one that is not split system couple of months ago and was not happy with it.

This little thing really surprised me. Why ?

Well, let's start.

Most of AIO systems are in one piece. This is split system meaning that VTX is separated from the camera.
Though non split systems are good for micro quads, if you are planing to use FPV on micro airplanes like UMX series from Parkzone, that could be the problem.
Those micro airplanes are very light and adding AIO FPV on them will change the CoG of that airplane, so flying will be almost impossible.
That is where this split system comes. You can put a camera on the nose and move VTX little further away to have correct CG on the plane.

Or maybe you want your camera to be inside canopy and VTX outside.

Another problem with system that are all in one piece might be that you would like to add OSD.
OSD comes in between of camera video signal and transmitter, and since…